Containerized Battery Storage (CBS) is a modern solution that encapsulates battery systems within a shipping container-like structure, offering a modular, mobile, and scalable approach to energy storage.
To address this challenge, battery energy storage systems (BESS) are considered to be one of the main technologies . Every traditional BESS is based on three main components: the power converter, the battery management system (BMS) and the assembly of cells required to create the battery-pack .
Why should a battery pack be modular?
This is because the reusability of the design and even the repair or replacement of cells becomes much more challenging in a battery-pack with a large number of cells. Modularity allows easily customizing the design for different voltage, power and energy levels.
How reliable are modular battery packs?
According to these results, the reliability of modular battery-packs is up to 20.24 % over the conventional BESSs for energy applications. With regards to power applications, the modular configurations' reliability is up to 16.21 % higher than the MTTF corresponding to the conventional BESS. Table 4. Top MTTF results at 0.5 C for modular BESSs.
Are new technology solutions required for more reliable modular battery-packs?
With the results obtained in this research, it is numerically demonstrated that new technological solutions towards more reliable modular BESSs are mandatory. In parallel, this improvement may enable the incorporation of new control strategies and new replacement systems of damaged battery-packs.
Can a modular battery-pack solve a cell-to-cell imbalance?
However, as the cell to cell imbalances tend to rise over time, the cycle life of the battery-pack is shorter than the life of individual cells. New design proposals focused on modular systems could help to overcome this problem, increasing the access to each cell measurements and management.
Why is modularity important?
Modularity allows easily customizing the design for different voltage, power and energy levels. According to, using these new solutions it is possible to avoid problems like power and voltage stress in the power electronic components.